Epoxy.com’™ Product #1W
100% Solids High-Build Epoxy Wall Coating
Thicker Bodied Epoxy Coating for Use on Verticals and Overhead
Product #1W High Build Epoxy Wall Coating – epoxy coating for walls, is a two component, 100% solids epoxy Hi-Build epoxy wall coating used for high indoor traffic areas where abrasion resistance is required; for protection against mild corrosion; and as a decorative waterproof coating for walls, tanks, etc.
Ceramic like finish
Thicker Bodied Epoxy Makes it an Excellent for Floors and Ceilings
Surfaces to receive Product #1W High Build Epoxy Wall Coating must be clean and sound. Remove all dirt, laitance, grease curing compounds and other foreign matter by sandblasting, mechanical abrasion, or acid etching. Remove water and dust from all surfaces with an oil-free blast immediately prior to application.
Temperature of Product #1W High Build Epoxy Wall Coatingmust be 50 degrees F or above at time of mixing. Stir each component separately before blending. Mix 4 parts by volume of Part A with 1 part by volume of Part B for three minutes with a low speed electric drill motor equipped with a mixing paddle.
Apply Product #1W High Build Epoxy Wall Coating with a roller, brush, or spray equipment. Two coats are recommended. Thickness per coat should be 7-10 mils. Seven days cure time is required to reach maximum chemical resistance.
DO NOT apply Product #1W High Build Epoxy Wall Coating at temperatures below 40° F. Surface must be dry.
Prolonged or repeated exposure may cause eye and skin irritation. If contact occurs, wash immediately and seek medical help. Use safety glasses with side shields and wear protective rubber gloves.
Clean Product #1W High Build Epoxy Wall Coating from all tools and equipment should be cleaned before the system gels. Use MEK, Acetone, or any lacquer solvent.
APPLICATION PROPERTIES @77° F
Mix Ratio 4:1 By Volume
Viscosity (mixed) 2000 -2500 CPS
Pot Life (200 gr.) 40-50 minutes
Tack Free to Touch 8 to 10 Hours
Initial Cure 24 Hours
Final Cure 7 Days
Packaging Unit Size 1.25 gal. unit, 5 gallon unit
Standard Colors White, Light Gray, Dark Gray, Taupe, Sand, Old Gold, Mocha, Brick Red, Slate Blue, Colonial Green, Deep Blue, Black, Safety Yellow
Customized Colors: Epoxy Systems, Inc. will customize colors to the client’s specifications. Dry samples will be provided for prior approval. Minimum orders and a premium charge may be required. All customized colors must be approved and may not be returned. An additional 14 working days will be required to match and produce customized colors.